The main Navigation tabs at top of each page are Metric - inputs in millimeters (mm) For Inch versions,
directly under the main tab is a smaller 'Inch' tab for the Feet and Inch version.
Drop Down Menus have M for Metric Versions.
Tile Fit, Spacing, Cut and Joint Calculator
Enter dimensions to calculate best fit, joint gap and end cuts by trying different combinations of tile size, joint width and end cutting etc.
Floor Width
Tile Width
Joint Width
- joint between tile and wall
Fit tiles to floor width
and cut last tile to fit
Floor Width
Joint Width
Scale
Running points from edge of floor to far side of each tile Highlight every
entry
Mark-out
Always layout and verify dimensions on-site before cutting.
?
Select output Fraction Precision, Decimal Inch or Metric mm. Select and Re-Calculate to display.
Fraction Precision
All Inch inputs and dimensions are actual physical finished sizes(unless otherwise noted)
All Metric Inputs in Millimetres(unless otherwise noted)
If you're cutting blocks, concrete, stone or ANYTHING and there's DUST - DON'T TAKE THE RISK
Don't cut it, or cut it wet so there's NO DUST - Silicosis Sucks
And if you're cutting wet, wear a mask - theres dust in the spray mist too!
How should we spell it?
Results
What do we think? - They're 2 different things:
A Meter is a device to measure things - like a Volt Meter or a Parking Meter
A Metre is about 3'-3~3/8"
Although diameter and perimeter as measurements - don't seem to fit very well
If the US ever goes Metric, you'll be able to use a Meter to measure Meters - A Meter Meter
(And when we go back to the moon, let's go Metric, ay?)
Built something using our calculators?
Please Send Photos!See examples
Built something using this site?
Please Send Photos! See Examples
blocklayer.com
If you've benefited from this free service please consider supporting:
Inch or Metric?👈
The main Navigation tabs at top of each page are Metric - inputs in millimeters (mm)
Directly under the main tab is a smaller 'Inch' tab for the Feet and Inch version.
Drop Down Menus have M for Metric Versions.