The first (blue) measurement is the correct diagonal at Gauge. The next is the correct
measurement if you're 10 mm low. The smaller red Error number is the Plumb
Error for this course at this gauge error. If the Error measurement becomes
significant, use the appropriate diagonal measurement for your gauge error.
Pull your tape from the origin point and using a fine tipped white marker, mark the correct measurement for
each course. Lay the blocks with their centre top to the tape mark.
As any deviation to gauge will cause plumb errors, the sheet lists correct measurements for variance in gauge,
as well as plumb errors for gauge variance.
Check the gauge occasionally and if the plumb error is significant, use the alternate measurement on the sheet.
The calculator sets the circle or arc out to suit blocks, giving the inside
and outside perp measurements and allowing you to open or tighten the perps (bond) in quarter block increments to a suitable size.
It calculates the 'block + perp' outside measurement, so you can check your bond as you go around. Eg: if the outside 'block + perp' is 418 mm, and you've
laid 10 blocks on the way around, 10 X 418 is 4180. Pull a tape around the outside of the arc to see if you're 'back' or 'forward'.
Angle of Rotation
Running Bond around outside (from outside start of first (or any) stretcher, to end of each block)
You can combine this Circular Wall System with the Gable Cutting System to easily build curved or circular raking walls.
Neither system requires a string line, so they combine easily. You can also use the Templateless Arch System
to build arches or bulls-eyes in your circular raking wall. It's easy!
If you'd like more detailed info on this, please contact us.
If you're cutting concrete, stone or ANYTHING and there's DUST - DON'T TAKE THE RISK
Don't cut it, or cut it wet so there's NO DUST - Silicosis Sucks
How should we spell it?
What do we think? - They're 2 different things:
A Meter is a device to measure things - like a Volt Meter or a Parking Meter
A Metre is about 3'-3~3/8"
Although diameter and perimeter as measurements - don't seem to fit very well
If the US ever goes Metric, you'll be able to use a Meter to measure Meters - A Meter Meter
All Imperial inputs and dimensions are actual physical finished sizes(unless otherwise noted)
All Metric Inputs in Millimetres(unless otherwise noted)