blocklayer.com Directory
? 👈
Inch or
Metric
The main Navigation tabs at top of each page are Metric - inputs in millimeters (mm)
For Inch versions, directly under the main tab is a smaller 'Inch' tab for the Feet and Inch version.
Help
Search
by Image



Cone Pattern Templates - Print at 100% Printer Scale

Enter Top Width, Bottom Width and Height of the cone (see diagram) and hit Calculate to draw a full scale printable pattern template to mark out the cone.

To mark holes or lines around the cone, check Holes or Lines and enter number of Incremetns. Enter hole Slant Height up slanting edge of the cone and Hole Diameter and hit Draw.

Large Cone Layout For very large cones (base or height over 600), or when Full Scale is un-checked (diagram is not Full Scale), check Dimensions to show correct measurements to mark out cone.
Volume Calibration See Volume Calibration Templates to mark incremental fluid volumes on cone.

Cone cutting pattern calculator profile diagram
Top Width
Base Width
Height
?
Show Dimensions on template
?
Draw diagram at 100% scale to print and use as template.
Disabled if template over A0 size.
If not Full Scale, check Dimensions to label diagram
?
Add tab to overlap and join template edges. (Only with full Template - not segments)
?
Show Template bounding rectangle with dimensions
?
For large templates - divide into multiple IDENTICAL smaller segments for easier printing
Segments
Increments
Slant Height
Hole Diameter
↑ ↓
← →
Size
Fonts

Top Width Base Width Height

Cone pattern full scale cutting template




Click and drag 3D Model to re-orient.



Volume Calibration See Printable Fluid Volume Calibration Templates to mark fluid volumes on cone.

Hit Diagrams to PDF (below) to create a PDF file up to paper size A0 (1189mm x 841mm) for large templates. Send to a Print Shop for plan printing, or to print a large template image over multiple pages, see Printing Tips




DON'T BREATH THE DUST If you're cutting blocks, concrete, stone or ANYTHING and there's DUST - DON'T TAKE THE RISK
Don't cut it, or cut it wet so there's NO DUST - Silicosis Sucks
And if you're cutting wet, wear a mask - theres dust in the spray mist too!

How should we spell it?



Results


Built something using our calculators? Please Send Photos! See examples

Blue Dragon Childrens Foundation If you've benefited from this free service please consider supporting Blue Dragon Children's Foundation



Please help promote this free service - Tell a Friend about this site!

Create PDF to print diagrams on this page. Help Printing Help (new window)

Copy all diagrams on this page to bottom of page - Make multiple copies to Print or Compare.

View page on Phone via QR Code (Not current calculation result)

?
Zoom out to fit large full scale template images on screen - or to adjust scale to match ruler held against screen
Zoom 100%

?
Zoom to adjust screen scale to actual size (measure full scale diagram with ruler) and hit 'Set' to set scale on other pages.


?
Click Slider to select then use keyboard cursor keys to fine tune.
Keyboard
Fine tune Sliders
?
Create and Print Full Scale PDFs with diagrams on this page (templates)

?
Copy all diagrams on this page to bottom of page - Make multiple copies to Print or Compare Results



PDF & Printing Help

Help Share

← Remove Margins

Jump to Top ↑

Built something using this site?
Please Send Photos!
See Examples
blocklayer.com calculators
If you've benefited from this free service please consider supporting: Please help us support Blue Dragon Children's Foundation

Vietnamese Lawyer Saving Women Trafficked to China

Contact Us

blocklayer.com calculators

All calculators on this site are geometric only.
Check relevant local regulations for appropriate sizes, spacings and all engineering requirements.


Disclaimer   |   Privacy & Cookie Policy

Copyright © 2020 - blocklayer.com
Contact Us