Cone Pattern Templates - Print at 100% Printer Scale
Enter Top Width, Bottom Width and Height of the cone (see diagram) and hit Calculate
to draw a full scale printable pattern template to mark out the cone.
To mark holes or lines around the cone, check Holes or Lines and enter number of Incremetns.
Enter hole Slant Height up slanting edge of the cone and Hole Diameter.
and hit Draw.
For large templates - divide into multiple IDENTICAL smaller segments
Template Segments
Incremetns
Slant Height
Hole Diameter
↑ ↓
← →
Size
Fonts
Top Width
Base Width
Height
Hit Diagrams to PDF (below) to create a PDF file up to paper size A0 (1189mm x 841mm) for large templates.
Send to a Print Shop for plan printing, or to print a large template image over multiple pages, see Printing Tips
?
Select output Fraction Precision, Decimal Inch or Metric mm. Select and Re-Calculate to display.
Fraction Precision
All Inch inputs and dimensions are actual physical finished sizes(unless otherwise noted)
All Metric Inputs in Millimetres(unless otherwise noted)
If you're cutting blocks, concrete, stone or ANYTHING and there's DUST - DON'T TAKE THE RISK
Don't cut it, or cut it wet so there's NO DUST - Silicosis Sucks
And if you're cutting wet, wear a mask - theres dust in the spray too!
How should we spell it?
Results
What do we think? - They're 2 different things:
A Meter is a device to measure things - like a Volt Meter or a Parking Meter
A Metre is about 3'-3~3/8"
Although diameter and perimeter as measurements - don't seem to fit very well
If the US ever goes Metric, you'll be able to use a Meter to measure Meters - A Meter Meter
(And when we go back to the moon, let's go Metric, ay?)
Built something using our calculators?
Please Send Photos!See examples
See Volume Calibration Templates to mark fluid volumes on cone.
If you're cutting blocks, concrete, stone or ANYTHING and there's DUST - DON'T TAKE THE RISK
blocklayer.com
blocklayer.com
