blocklayer.com
Directory
👈 Inch or Metric
Search by Image
Bullnose Roof Sheeting Calculator Enter roof run and angles to calculate sheet dimensions. Drag Sliders to animate.
|
|
|
The Curve Radius is the distance from the curve surface (Red) to the centre of the circle it forms. The smaller the radius, the tighter the curve.
The Sweep Angle determines the 'length' of the curve, and is the section of the circle that forms the curve.
Roof Angle + Sweep Angle must not exceed 90 °.
Check Radius ~ Sweep to show the radius lines to centre and sweep angle.
|
Run
Roof°
Sweep°
Curve
End
|
Fraction Precision
|
All Inch inputs and dimensions are actual physical finished sizes (unless otherwise noted)
|
All Metric Inputs in Millimetres (unless otherwise noted)
If you're cutting blocks, concrete, stone or
ANYTHING and there's
DUST - DON'T TAKE THE RISK
Don't cut it, or cut it wet so there's
NO DUST -
Silicosis Sucks
And if you're cutting wet, wear a mask - theres dust in the spray too!
What do we think? - They're 2 different things:
A
Meter is a device to measure things - like a Volt Meter or a Parking Meter
A
Metre is about 3'-3~3/8"
Although diameter and perimeter as measurements - don't seem to fit very well
If the US ever goes Metric, you'll be able to use a Meter to measure Meters - A Meter Meter
(And when we go back to the moon, let's go Metric, ay?)
Built something using our calculators?
Please
Send Photos!
See examples
blocklayer.com
If you've benefited from this free service please consider supporting
Built something using our calculators?
Please
Send Photos!