blocklayer.com
Directory
?
👈
Help
👈
Inch or
Metric
Metric
The main Navigation tabs at top of each page are Metric - inputs in millimeters (mm)
For Inch versions, directly under the main tab is a smaller 'Inch' tab for the Feet and Inch version.
Drop Down Menus have M for Metric Versions.
For Inch versions, directly under the main tab is a smaller 'Inch' tab for the Feet and Inch version.
Drop Down Menus have M for Metric Versions.
|
With Square cut rafter ends, the fascia is set to the complement of roof angle. The Hip lower end miter and side angles need to be adjusted to join. This calculator shows Hip lower end miter and side cuts, and fascia miter and bevel cuts to match the square tail fascia angles.
If you're cutting blocks, concrete, stone or ANYTHING and there's DUST - DON'T TAKE THE RISK
Don't cut it, or cut it wet so there's NO DUST - Silicosis Sucks And if you're cutting wet, wear a mask - theres dust in the spray mist too!
Built something using our calculators?
Please Send Photos!
See examples
If you've benefited from this free service please consider supporting
Blue Dragon Children's Foundation
Please help promote this free service -
Tell a Friend about this site!
Create PDF to print diagrams on this page. Help Printing Help (new window) Copy all diagrams on this page to bottom of page - Make multiple copies to Print or Compare. View page on Phone via QR Code (Not current calculation result) ?
Zoom 100%
Zoom out to fit large full scale template images on screen - or to adjust scale to match ruler held against screen
?
Zoom to adjust screen scale to actual size (measure full scale diagram with ruler) and hit 'Set' to set scale on other pages.
?
Keyboard ◄ ►Click Slider to select then use keyboard cursor keys
◄ ► to fine tune.
Fine tune Sliders ?
Create and Print Full Scale PDFs with diagrams on this page (templates)
?
Copy all diagrams on this page to bottom of page - Make multiple copies to Print or Compare Results
PDF & Printing Help Help Share ← Remove Margins Jump to Top ↑
blocklayer.com
If you've benefited from this free service please consider supporting:
Inch or Metric?
👈
The main Navigation tabs at top of each page are Metric - inputs in millimeters (mm)
Directly under the main tab is a smaller 'Inch' tab for the Feet and Inch version. Drop Down Menus have M for Metric Versions.
Please help promote this free service
Tell a Friend! 
blocklayer.com
All calculators on this site are geometric only. Check relevant local regulations for appropriate sizes, spacings and all engineering requirements. Disclaimer | Privacy & Cookie Policy Copyright © 2021 - blocklayer.com |
||||||||||||||||
